Interior Exterior
Q:
Anyone notice their rear brackets don't fully meet up? Mine has a little gap even when the bolts are fully tightened. I had some wind noise today, and it went away when I pulled the hard top down a bit.
A:
I have the same problem. I had to put a small piece of rubber in the hook of the rear bracket to make them snug. I found that when I stored the hard top upright, leaned against the wall, the whole roof curls up to a degree so when it's placed back on the car, the center section bulges up and the side edges were already flush so I had the gap in the bracket. It was better when I stored the roof flat, interior aspect facing up. Then the center bulged less and the sides were a little separated so tightening the bolt actually pulled the roof snug.