Interior Exterior
Q:
i got around to getting them out today. the trick is, which i don't remember reading about, to pry with something thin between the mesh and the ring it sits in (but not between the ring and the dashboard) while grabbing the mesh with your other hand and pulling up. once i figured this out, it was very easy. prior to this i was trying to put something through the mesh and pull up this way, but apart from breaking whatever i was using, that wasn't doing anything.
another trick applies when getting the screws out from the speakers. the windshield glass is so close to some of the screws that a regular screwdriver will not fit. instead, i used a drill bit that i turned with the smallest wrench in my set that just fit perfectly.
there was no need to remove any seats (althogh that would have made it a little easier). it looks to me that it takes much more effort to remove the seats than the effort saved in removing the speakers.
getting off topic somewhat: i got the speakers loose. there are two wires going from each. one wire ends with a connector so that should make it easy to disconnect and reconnect later if necessary. but the other wire appears soldered to the speaker. how am i supposed to remove this wire from the speaker? just break the solder off? and then i would have to solder it back on if i want to put the spakers back in?
A:
I have one speaker where the grill popped out and I can't get it to say back in.
Oh well.