A&Q about 350Z
Q:
I'm getting very frustrated... ok heres the situation, I recently bought a Prostart CT-3300 from Canadian Tire (canada of course) and I've been trying to install it.. it took a while but i finally got to the point where it was turning over, and it would start but then imediately shut off. I figured that i must have had the wrong tach lead so i found what i think is the right one and tried it.. and it worked.. well for about 10 starts.. now its back to where i was before.. its starting then immediately cutting off... any suggestions?
A:
Jay,
I have the same prostart model, but I havn't tried to install it yet, but the manual says you have to put the module through a "tach learning" process. Check your installation manual.
That may be the problem, otherwise I don't know.
A:
OK guys. I just installed the Prostart 3300. I suggest you try putting a key in the ignition and try the remote starter. If this works then I am assuming your ignition is protected by a passlock or passkey system, which will require a bypass module. Good Luck.