A&Q about 350Z
Q:
Several of you fellow Z owners recommended that I add front and rear adjustable camber arms to correct my tire wearing problem on my '96 300 ZX. Are the ones from Stillen the best to purchase and if so, have any of you installed them yourselves?
Any info would be greatly appreciated.
Pearl Z
'96 300 ZX
Eibach springs
KYB struts
Stillen cat back
A:
Bad shocks/struts can be responsible for uneven tire wear. Another thought would be wheel alignment or toe in might need adjusted.
A:
Stillens are ok, but they are expensive. from your list of mods you have already installed the springs and struts? if so you will need that correction ASAP..I went a cheaper but just as effective route to correct my neg camber after I installed my eibach's.. I installed all of the mods listed in my sig and then some not listed..It’s not hard to do, but it can be time consuming.
90 Diamond Metallic Black NA -- In repair mode
A:
Z-Daddy,
Where did you purchase the suspension parts and how much were they?
Pearl Z
A:
300deg camber kit was purchased from http://www.sgpracing.com $80+shipping, adjustable rear upper A arms are top speed (ebay special) $95 no shipping (picked up locally), and the Powertrix Adjustable tension rods purchased from cpark@powertrix.com (highly recomend) $169 shipped.
I purchased them in that order, and if I had it to do over again (and I had the funds) I would have purchased only powertrix adjustable's from cpark because of great service and his prices were cheaper (shipped) than anyone else I found.
90 Diamond Metallic Black NA -- In repair mode
A:
Here is the link for powertrix stuff
http://www.twinturbo.net/net/viewmsg.aspx?forum=classified&msg_id=103982
90 Diamond Metallic Black NA -- In repair mode