A&Q about 350Z
Q:
Hi,
Here a technical question for you.
Can someone tell me the coil impedance of the fuel injector that controls the cold start on a K-Jet 16v engine?
Cheers
Martin
A:
Hi
What will that prove or disprove ?
A:
Hi Mattkh,
I'm trying to find out if the Aquamist MF2 mappable fuelling system will fire a kr cold start vlave. If the ohm reading is ok and the MF2 will work this injector I'm going to use cold start valves as extra injectors on my 2.1 16v Turbo conversion.
Do you have a reading?
Cheers
Martin
A:
I'll be going outside in a minute and could measure this for you, providing I can find the manifold I have kicking around.
A:
Hi Trev 16v,
If you would do that, it'll help me out.
Also I need to know what size and cut is on the mk2 golf oil pressure and temperature switches? I think its 1/8 NPT but need this confirmed. I need to get a t piece to connect up my oil pressure sender and run a turbo oil feed pipe.
Cheers
Martin
A:
with the meter on a 200ohm setting , the screen shows 4.4 if thats any help
A:
Thanks pigbladder,
I will relay that back to Aquamist and see, I think I read in the online instruction manual that the MF2 will fire injectors to 5 ohm.
I'd appreciate some other readings to establish a baseline figure, just to make sure, these old injectors may give differing readings.
Mart
A:
ive got a few of em...i'll measure the others when the rain stops